Spray nozzles is a small component that can comes very important also in car wash process, cause using a wrong nozzle you can have a poor quality wash and consequently lost customers.
CAR/TRUCK WASHING PLANTS
TUNNEL
In the following areas of the tunnel, there are some big roller brushes which rub the vehicle’s body. During this phase, water plus soap is sprayed by means of flat spray nozzles, like our C1 or MC3E, with a spray angle of 65°. Here spray nozzles are also fastened on arches by clamps. But in this case spray nozzles with almost low capacity are needed. Water is at a pressure of 5-6 bar. Otherwise we can find an adjustable arm with only one spray nozzle with a higher pressure (20 o 30 bar). In this case, our HP (High pressure) can be used, directly fastened on the arm, with the aim of cleaning the bodywork and, at the same time, removing filth from brushes. The HP-HHP nozzle type is also used for the vehicle’s under body washing, in plants where this is present. For side frames and wheelhouses washing, full cone nozzles (generally ¼” ) are used. The full cone spray permits an effective and uniform washing. To wash the front of the vehicle where they can remain stuck various insects, have been introduced on the most sophisticated systems high pressure nozzles HP-HHP-needle jet or with very narrow angle-mounted on mobile bars. This arrangement ensures the effective removal of spray of dirt-resistant nozzles where traditional mops and appear to be only partially effective. At the end of the various phases which depend on the tunnel’ s overall length , the vehicle is rinsed by means of a shower made by spray nozzles, usually flat jet because the vehicle is moving. Spray nozzles like our MC3 and C1 are used. In shorter washing plants there are some tubes with clamps made of plastic fastened on them and flat spray nozzles with low capacity (C1, MC3E etc.) for spraying of detergent, at a pressure of 2-4 bar. These clamps with nozzles alternate with high pressure spray nozzles (30-40 bar) well-suited to washing/rinsing (our HP). These spray nozzles are screwed straight to the tube.
CLAMPS FOR TUBES.
SELF-SERVICE WASHING
FILTERS
MB1 FULL CONE NOZZLES
FLAT JET NOZZLE
MC2 FLAT JET NOZZLE
MC3E FLAT JET NOZZLE
HIDRAULIC ATOMIZERS
Spraying of detergents as pre-washing: a fine atomization is needed for a lesser waste of product. Nozzles are used for spraying of perfume. Spraying of deodorizer. The nozzles are extremely cheap and permit atomization even at a pressure of 2 bars (for this reason they haven’t got a diaphragm valve), so without utilization of compressed air. Moreover, being mounted on self-service plants, their low price permits to reduce the economic damage if they should break or be stolen.
This type of nozzle allows to spray additives. Opinion of customers on our atomizers is that they clog less than comparable models of competition.